Differences

This shows you the differences between two versions of the page.

--- equipment:3dprinting:3dprinterpc [2015/08/25 08:16] – Anders Vestergaard
+++ equipment:3dprinting:3dprinterpc [2018/09/20 22:52] – Lars Christensen
@@ Line 15: / Line 15: @@
 Dprinter PC'en er beregnet til at slice dine STL-filer til G-code filer som 3D-printerne forstår.
-Cura version 15.04.02 er installeret samt opsat til [[equipment:3dprinting:lulzbot-taz]] og [[equipment:3dprinting:ultimaker]].
+Cura version 3.4.1 er installeret samt opsat til [[equipment:3dprinting:lulzbot-taz]] og [[equipment:3dprinting:ultimaker]].
+PCen kører Lubuntu 18.04 -- password står på skærmen.
+===== Kiosk Mode =====
+Settings in Cura are reset every time Cura is launched from the desktop.
+  * If the default settings are incorrect, or Cura needs to be updated, ask in #3dprinter on Slack
+Material must always be set to “Hal9k PLA”
+  * Otherwise, retraction settings will cause blockage.
+  * Use only 3 mm or less retraction distance with both printers.
+The PC installs updates and reboots at 4 AM, every day.
+https://github.com/Hal9k-dk/cura-kiosk
-PCen kører Lubuntu 14.10 -- password står på skærmen.