Differences

This shows you the differences between two versions of the page.

--- equipment:3dprinting:lulzbot-taz [2016/11/20 17:20] – old revision restored (2016/11/19 16:48) Torsten Martinsen
+++ equipment:3dprinting:lulzbot-taz [2017/01/25 08:02] – Torsten Martinsen
@@ Line 18: / Line 18: @@
 ^ Nozzle | 0.5 mm |
-^ Filament typer | PLA ABS |
+^ Filament typer | PLA, ABS |
 Original TAZ 3 extruder
@@ Line 27: / Line 27: @@
 ^ Nozzle | 0.35 mm |
-^ Filament typer  | PLA NinjaFlex |
+^ Filament typer  | PLA, NinjaFlex |
 Taz [[https://ohai-kit.alephobjects.com/project/flexystruder_assembly/|flextruder]] selvbuild
@@ Line 35: / Line 36: @@
 ^ Layer height | 0.1 - 0.25 mm |
-^ Filament diagmenter | 2.85 mm - 3.00 mm (mål efter) |
+^ Filament diameter | 2.85 mm - 3.00 mm (mål efter) |
-^ Nozzle size | 0.5 mm (Original), 0.35 mm (flextruder) |
+^ Nozzle size | 0.5 mm (original), 0.35 mm (flextruder) |
 ^ Print temperature | 210 degrees (PLA) |
 ^ Bed temperature | 60 degrees (PLA) |
@@ Line 77: / Line 78: @@
 ===== Firmware =====
-Firmwaren ligger på [[https://github.com/Hal9k-dk/3D-Printere/tree/master/LulzBot-firmware]]
+Firmwaren ligger på [[https://github.com/Hal9k-dk/Marlin]], branch ''hal9k-taz3''.
+===== Kamera =====
+Der er monteret en Raspberry Pi med kamera, som kan nås via IPv6 på http://[2001:470:7fa9:3:ba27:ebff:fe5e:51c2]:8080/stream.html