This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
equipment:3dprinting:vyper [2023/04/16 15:03] – Torsten Martinsen | equipment:3dprinting:vyper [2023/08/08 15:55] – [Pause at height] Morten Frederiksen | ||
---|---|---|---|
Line 37: | Line 37: | ||
Print status is available in the #octoprint Slack channel, along with some basic controls. Try typing " | Print status is available in the #octoprint Slack channel, along with some basic controls. Try typing " | ||
+ | |||
+ | ===== Pause at height ===== | ||
+ | |||
+ | In Cura there is an extension to insert GCode to pause at a specified height (layer number) in the print (e.g. for inserting embedded nuts or other objects), however, the [[https:// | ||
+ | |||
+ | If printing over the inserted object, it may be a good idea to preheat the object on the print bed before inserting and resuming the print. | ||
+ | |||
====== Links ====== | ====== Links ====== |