This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
equipment:3dprinting:vyper [2023/08/08 15:54] – Morten Frederiksen | equipment:3dprinting:vyper [2023/08/08 15:55] – [Pause at height] Morten Frederiksen | ||
---|---|---|---|
Line 40: | Line 40: | ||
===== Pause at height ===== | ===== Pause at height ===== | ||
- | In Cura there is an extension to insert GCode to pause at a specified height (layer number) in the print (e.g. for inserting embedded nuts or other objects), however, the [[https:// | + | In Cura there is an extension to insert GCode to pause at a specified height (layer number) in the print (e.g. for inserting embedded nuts or other objects), however, the [[https:// |
If printing over the inserted object, it may be a good idea to preheat the object on the print bed before inserting and resuming the print. | If printing over the inserted object, it may be a good idea to preheat the object on the print bed before inserting and resuming the print. |