This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
equipment:powertools:drejebaenk [2015/05/20 15:30] – Torsten Martinsen | equipment:powertools:drejebaenk [2016/10/20 21:09] (current) – Torsten Martinsen | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Lille drejebænk ====== | ====== Lille drejebænk ====== | ||
- | |||
- | |||
- | |||
- | {{http:// | ||
===== Beskrivelse ===== | ===== Beskrivelse ===== | ||
{{ : | {{ : | ||
Line 13: | Line 9: | ||
^Lokale | Prototypeværksted | | ^Lokale | Prototypeværksted | | ||
^Tilladt brug | No hacking allowed. Alm. brug er tilladt hvis man ved hvad man laver | | ^Tilladt brug | No hacking allowed. Alm. brug er tilladt hvis man ved hvad man laver | | ||
+ | |||
+ | **OBS:** I skrivende stund kan pinoldokken ikke fastspændes, | ||
300 mm drejelængde og 90 mm pinolhøjde. | 300 mm drejelængde og 90 mm pinolhøjde. | ||
Line 60: | Line 58: | ||
===== Drejestål ===== | ===== Drejestål ===== | ||
- | DIN 4974 R Internal side turning tools for corner work with carbide tips. | + | Se [[equipment:powertools: |
- | DIN 4973 R Boring tools with carbide tips. | + | |
- | DIN 4980 L Offset side turning tools with carbide tips. | + | |
- | DIN 4980 R As above but right handed. | + | |
- | DIN 4978 R Offset turning tools for corner work with carbide tips. | + | |
- | DIN 4971 R Straight turning tools with carbide tips. | + | |
- | DIN 4972 R Bent turning tools with carbide tips. | + | |
- | DIN 4977 R Offset face turning tools with carbide tips. | + | |
- | DIN 4981 R Parting-off tools with carbide tips. | + | |
- | DIN 4976 Wide face square nose tools with carbide tips. | + | |
- | DIN 4975 Pointed straight turning tools with carbide tips. | + | |
- | + | ||
- | {{:equipment:lathetools.gif?600|}} | + | |
===== Brugermanual ===== | ===== Brugermanual ===== | ||
Line 82: | Line 68: | ||
{{: | {{: | ||
- | {{http://youtube.com/v/gfMEkIEFoq0? | + | {{youtube>gfMEkIEFoq0}} |