Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| equipment:3dprinting:3dprinterpc [2015/08/05 20:00] – Anders Vestergaard | equipment:3dprinting:3dprinterpc [2022/05/01 10:49] (current) – Lars Christensen | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ^ QR-ID | HQR1016 | | ^ QR-ID | HQR1016 | | ||
| - | ^ Navn | 3DPrinterPC | | + | ^ Navn | 3DPrinterPC | |
| ^ Kort beskr. | ^ Kort beskr. | ||
| - | ^ Indehaver | HAL9k | | + | ^ Indehaver |
| - | ^ Tovholder | [[members: | + | ^ Tovholder |
| - | ^ Tilladt brug | No hacking allowed. Alm. brug tilladt | | + | ^ Tilladt brug | No hacking allowed. Alm. brug tilladt | |
| - | ^ Placering | Er placeret | + | ^ Placering |
| {{: | {{: | ||
| Line 15: | Line 15: | ||
| 3Dprinter PC'en er beregnet til at slice dine STL-filer til G-code filer som 3D-printerne forstår. | 3Dprinter PC'en er beregnet til at slice dine STL-filer til G-code filer som 3D-printerne forstår. | ||
| - | Cura version 15.04.02 | + | Cura er installeret samt opsat til [[equipment: |
| + | |||
| + | PCen kører Lubuntu -- password står på skærmen. | ||
| + | |||
| + | ===== Kiosk Mode ===== | ||
| + | |||
| + | Settings in Cura are reset every time Cura is launched from the desktop. | ||
| + | |||
| + | * If the default settings are incorrect, or Cura needs to be updated, ask in #3dprinter on Slack | ||
| + | |||
| + | Material must always be set to “Hal9k PLA” | ||
| + | |||
| + | * Otherwise, retraction settings will cause blockage. | ||
| + | * Use only 3 mm or less retraction distance with both printers. | ||
| + | |||
| + | The PC installs updates and reboots at 4 AM, every day. | ||
| + | |||
| + | https:// | ||
| - | PCen kører Lubuntu 14.10 -- password står på skærmen. | ||