Differences

This shows you the differences between two versions of the page.

--- equipment:3dprinting:ultimaker [2018/03/11 14:41] – [Ultimaker] Anders Vestergaard
+++ equipment:3dprinting:ultimaker [2018/03/15 18:13] (current) – Anders Vestergaard
@@ Line 11: / Line 11: @@
-**NYE BILLEDER PÅ VEJ**
+{{:equipment:3dprinting:2018-03-15_17.33.26.jpg?direct&400|}}
+{{:equipment:3dprinting:2018-03-15_17.33.33.jpg?direct&400|}}
-{{:equipment:ultimaker.jpg?direct&400|}}
 ===== Print setting =====
@@ Line 28: / Line 29: @@
 ^ Retraction speed:| 60 mm/s |
+==== Start gcode ====
+<code>
+G21        ;metric values
+G90        ;absolute positioning
+M82        ;set extruder to absolute mode
+M107       ;start with the fan off
+G28 Z0     ;move Z to min endstops
+G28 X0 Y0                              ;move X/Y to min endstops
+G1 X10 Y10 Z15.0 F1000 ;move the platform down 15mm
+G92 E0                  ;zero the extruded length
+G1 F200 E3              ;extrude 3mm of feed stock
+G92 E0                  ;zero the extruded length again
+;Put printing message on LCD screen
+M117 Printing...
+</code>
+==== Stop gcode ====
+<code>
+;End GCode
+M104 S0                     ;extruder heater off
+M140 S0                     ;heated bed heater off (if you have it)
+G91                                    ;relative positioning
+G1 E-2 F300                            ;retract the filament a bit before lifting the nozzle to release some of the pressure
+G1 Z+0.5 E-3 X-20 Y-20 F1000 ;move Z up a bit and retract filament even more
+G28 X0 Y0                              ;move X/Y to min endstops
+G28 Z0     ;move Z to min endstops so the head is out of the way
+M84                         ;steppers off
+M107                       ;Turn fan off
+G90                         ;absolute positioning
+</code>
 ===== Betjening af Ultimaker =====

User Tools

Site Tools

Differences

Page Tools