This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
equipment:3dprinting:ultimaker [2018/03/11 19:12] – [Start gcode] Anders Vestergaard | equipment:3dprinting:ultimaker [2018/03/15 18:13] (current) – Anders Vestergaard | ||
---|---|---|---|
Line 11: | Line 11: | ||
- | **NYE BILLEDER PÅ VEJ** | + | {{: |
+ | {{: | ||
- | {{: | ||
===== Print setting ===== | ===== Print setting ===== | ||
Line 44: | Line 45: | ||
</ | </ | ||
==== Stop gcode ==== | ==== Stop gcode ==== | ||
+ | < | ||
;End GCode | ;End GCode | ||
M104 S0 ; | M104 S0 ; | ||
- | |||
M140 S0 ; | M140 S0 ; | ||
- | |||
G91 ;relative positioning | G91 ;relative positioning | ||
- | |||
G1 E-2 F300 ;retract the filament a bit before lifting the nozzle to release some of the pressure | G1 E-2 F300 ;retract the filament a bit before lifting the nozzle to release some of the pressure | ||
- | |||
G1 Z+0.5 E-3 X-20 Y-20 F1000 ;move Z up a bit and retract filament even more | G1 Z+0.5 E-3 X-20 Y-20 F1000 ;move Z up a bit and retract filament even more | ||
- | |||
G28 X0 Y0 ;move X/Y to min endstops | G28 X0 Y0 ;move X/Y to min endstops | ||
- | |||
G28 Z0 ;move Z to min endstops so the head is out of the way | G28 Z0 ;move Z to min endstops so the head is out of the way | ||
- | |||
M84 ; | M84 ; | ||
- | |||
M107 ;Turn fan off | M107 ;Turn fan off | ||
- | |||
G90 ; | G90 ; | ||
+ | </ | ||
===== Betjening af Ultimaker ===== | ===== Betjening af Ultimaker ===== | ||