Differences

This shows you the differences between two versions of the page.

--- projects:bungard-grbl [2018/07/19 20:10] – Lars Christensen
+++ projects:bungard-grbl [2018/07/19 20:22] – Lars Christensen
@@ Line 26: / Line 26: @@
 {{ :projects:cnc_diagram.svg |}}
+===== GRBL Configuration =====
+^ Settings ^ Description ^ Changed |
+| $0=10        | Step pulse, microseconds |
+| $1=255       | Step idle delay, milliseconds | 255=Keep motors on |
+| $2=0         | Step port invert, mask |
+| $3=0         | Direction port invert, mask |
+| $4=0         | Step enable invert, boolean |
+| $5=0         | Limit pins invert, boolean |
+| $6=0         | Probe pin invert, boolean |
+| $10=1        | Status report, mask |
+| $11=0.010    | Junction deviation, mm |
+| $12=0.002    | Arc tolerance, mm |
+| $13=0        | Report inches, boolean |
+| $20=1        | Soft limits, boolean | TRUE=stay inside limits |
+| $21=0        | Hard limits, boolean |
+| $22=1        | Homing cycle, boolean | TRUE=enabled |
+| $23=3        | Homing dir invert, mask | X/Y at min, Z at max |
+| $24=25.000   | Homing feed, mm/min |
+| $25=500.000  | Homing seek, mm/min |
+| $26=250      | Homing debounce, milliseconds |
+| $27=1.000    | Homing pull-off, mm |
+| $30=1000     | Max spindle speed, RPM |
+| $31=0        | Min spindle speed, RPM |
+| $32=0        | Laser mode, boolean |
+| $100=80.000  | X steps/mm | 80 at quartermicrostep |
+| $101=80.000  | Y steps/mm | 80 at quartermicrostep |
+| $102=71.000  | Z steps/mm | 71.0 at quartermicrostep |
+| $110=800.000 | X Max rate, mm/min |
+| $111=800.000 | Y Max rate, mm/min |
+| $112=800.000 | Z Max rate, mm/min |
+| $120=10.000  | X Acceleration, mm/sec2 |
+| $121=10.000  | Y Acceleration, mm/sec2 |
+| $122=10.000  | Z Acceleration, mm/sec2 |
+| $130=500.000 | X Max travel, mm | Work area |
+| $131=318.000 | Y Max travel, mm | Work area |
+| $132=200.000 | Z Max travel, mm | Work area |

User Tools

Site Tools

Differences

Page Tools