Differences

This shows you the differences between two versions of the page.

--- members:jenrik:enamel-pins [2021/06/12 19:10] – created Jener Rasmussen
+++ members:jenrik:enamel-pins [2022/02/12 20:41] (current) – Torsten Martinsen
@@ Line 11: / Line 11: @@
 ===== Step 1 =====
-Prepare a mask patter for the part of the design that need to be raised/lowered. Then print the mask on the overlay sheet.
+Prepare a mask pattern for the part of the design that need to be raised/lowered. Then print the mask on the overlay sheet.
 ===== Step 2 =====
@@ Line 20: / Line 20: @@
 ===== Step 3 =====
-Etch the design into the metal plate by dipping it in ferric chloride. Depending on how long the plate is in the solution the design gets embossed deeper. When done clean of the photoresist.
+Etch the design into the metal plate by dipping it in ferric chloride. Depending on how long the plate is in the solution the design gets embossed deeper. When done clean off the photoresist.
 ===== Step 4 =====
@@ Line 36: / Line 36: @@
 ===== Step 7 =====
-Add a attach mechanism, suggested is either a needle with cap, or a safety needle.
+Add an attach mechanism, suggested is either a needle with cap, or a safety needle.